Forum

 

Ender 3 Pro w/ 32bi...
 
Notifications
Clear all

Ender 3 Pro w/ 32bit 4.2.7 board - when to install new v.2 style display?


joel52334
(@joel52334)
Active Member Registered
Joined: 9 months ago
Posts: 5
Topic starter  

I got it up to the 1.0.1 firmware.  If I went any higher some BUZZER on the mainboard went nuts!

I got the v.2 style display with the new mainboard.  Which Ender 3 Pro firmware works with it?  I'm not going to use a BLTouch. 

There is a mod that you move the Z-Limit switch & it works like an Ender 6 v.2


ReplyQuote