Forum

 

Ender 3 Pro - diggi...
 
Notifications
Clear all

Ender 3 Pro - digging into print plate


dylan-3d-be
(@dylan-3d-be)
Active Member Registered
Joined: 5 months ago
Posts: 5
Topic starter  

Any ideas why the attached slice would dig into the print plate?

 

1 - It was printing fine on the mat

2 - I stupidly thought the underlay was glass so thought I'd give it try printing on it

3 - I thought it was printing for a while and then realised the filament wasn't spooling it and then I looked closer - ARGGhhh the plate was knackered!

 

Any ideas why this would have happened so I can ensure I don't do it again?


ReplyQuote
dylan-3d-be
(@dylan-3d-be)
Active Member Registered
Joined: 5 months ago
Posts: 5
Topic starter  

Here's the stl in case it's something I did in there...

This post was modified 5 months ago 2 times by dylan-3d-be

ReplyQuote
kevin
(@kevin)
Noble Member Registered
Joined: 8 months ago
Posts: 1045
 

@dylan-3d-be Oh, you printed on the magnetic plate. It is a little soft so the nozzle will scratch it if it is too close. 


ReplyQuote