Ender 3 Pro Board V...
 
Notifications
Clear all

Ender 3 Pro Board V4.2.2 RX TX


Lovdemord
(@lovdemord)
New Member Registered
Joined: 1 month ago
Posts: 2
Topic starter  

Hi is there a schematic from the V4.2.2 board for soldering or  getting RX and TX I want to use Wemos esp 8266 for wifi control. I`ve searched the internet did not found any results for that board or for the 4.2.7

If anyone have idea please share it thank you for the help.


ReplyQuote
Topic Tags
kevin
(@kevin)
Prominent Member Admin
Joined: 5 months ago
Posts: 900
 

@lovdemord That is the core information of Creality. I do not think that you can find it on the internet.


ReplyQuote
Lovdemord
(@lovdemord)
New Member Registered
Joined: 1 month ago
Posts: 2
Topic starter  

@kevin well too bad because there is already for v.1.1.4 board and for the cr-10 board basically for every 8 bit board


ReplyQuote
kevin
(@kevin)
Prominent Member Admin
Joined: 5 months ago
Posts: 900
 

@lovdemord Yes, the last generation motherboard 😆 


ReplyQuote
SiVa
 SiVa
(@siva)
Active Member Registered
Joined: 5 months ago
Posts: 9
 

V4.2.2 board schematics.

This post was modified 1 month ago 2 times by SiVa

ReplyQuote
SiVa
 SiVa
(@siva)
Active Member Registered
Joined: 5 months ago
Posts: 9
 

V4.2.7 board schematics.


ReplyQuote