Ender 3 Dislay is beeping continuously after Firmware Marlin2.0.1- V1.4.1- BLTouch - Filament - TMC2225
Hello and thank you for including me in the forum.
I have been using my Ender 3 successfully for 2 years. Since yesterday I have installed a new mainboard
Creality Upgrade Ender 3 Pro V4.2.7 Silent Motherboard with TMC2225 Driver with Firmware
Ender-3- Marlin2.0.1 - V0.0.6 - TMC2225.bin
This worked great.
Now I have installed a Creality V3.1 BLTouch Kit.
Since installing the firmware Ender-3 - Marlin2.0.1- V1.4.1- BLTouch - Filament - TMC2225.bin, the LCD display has been beeping very loudly.
When I install the other firmware again, the beeping is gone. But then i have no BLTouch support.
Does anyone have an idea what this could be?
Thanks a lot.
I have the same problem with my Ender 3 Pro.
My configuration :
Ender 3 Pro with 32 bits 4.2.7 mother board and BL touch.
I putted the firmware :
4.2.7 with BL touch 1.1.23 without transfert board
it's working well
Now i would like to add detector for filament.
So it's plug on motherboard.
The light is Green when filament is inside.
I need to update my mother board with :
Marlin2.0.1 BLtouch V1.4.1 with transfer board+filament detector TMC2225
But it's not working well
After upate i have continuous noize on display screen.
The update seems to be done because i have new menu with filament information.
Do you have a solution for this issue ?
For me it comes from transfert board.
I need this firmware without transfert board because i have pluged bl touch on directly on the mother board with 5 pins.
@3denderpro The official firmware has no without transfer board version firmware. You can only add the transfer board and flash this firmware if you want to add the filament detector.
Marlin2.0.1 BLtouch V1.4.1 with transfer board+filament detector TMC2225.