Forum

 

Ender 3 BLTouch Pro...
 
Notifications
Clear all

Ender 3 BLTouch Problems


torren
(@torren)
New Member Registered
Joined: 10 months ago
Posts: 1
Topic starter  

I have an Ender 3 with an SKR mini E3 V 1.2 and I recently have installed a BLTouch onto my printer. The BLTouch installed fine and I flashed the new firmware, however now when I try to auto bed level the printer rises about an inch above the printer bed and tries to auto bed level from up there. The BLTouch releases the probe and the Z-Axis moves down, but it only moves down a few millimeters than goes back up. My screen says-Setting Stored (722 byt es; crc 33304) but the BLTouch never even touch the build plate at all and after I attempt an ABL I cannot move the Z-Axis any lower than what it thinks zero is. I am very new to 3D printing and I have no idea what I am doing so any help would be greatly appreciated.


ReplyQuote