Forum

 

Ender 3, 32 Bit Boa...
 
Notifications
Clear all

Ender 3, 32 Bit Board (4.2.7) with Touchscreen and old BL Touch firmware


jmanson360
(@jmanson360)
New Member Registered
Joined: 3 months ago
Posts: 3
Topic starter  

I posted this in someone's reply and dont think I should have hijacked their thread even after it was resolved. 

I have an Ender 3 (not pro or v2) and got this:

Creality Ender 3 / Pro Color Display Screen and 4.2.7 32 Bit Silent Control Board with 2021 Marlin Firmware and Easy Installation Complete Plug and Play Upgrade Kit, Guide and Mounting Hardware

But i also had an old BLTouch laying around so I installed that too. 

 

When i powered up, everything worked, but no BL touch settings. Z axis worked but again, nothing about BL Touch. 

 

I flashed the touch screen, bl touch 4.2.7 firmware but now its bricked. Screen stays blank.

The BL Touch I got is this:

ANTCLABS BLTouch : Auto Bed Leveling Sensor/To be a Premium 3D Printer (With 1M Extension Cable Set)

Any help with this? 


ReplyQuote
jmanson360
(@jmanson360)
New Member Registered
Joined: 3 months ago
Posts: 3
Topic starter  

i installed another firmware and it has a leveling icon and whenever it tries to level, it goes up a little then just hangs and doesnt finish. Plus my z axis does not go down at all. 


ReplyQuote
CYT
 CYT
(@cyt)
Eminent Member Registered
Joined: 8 months ago
Posts: 46
 

@jmanson360 Adjust Z-limit switch? Or setting the z-offset to a negative value may help. 

 


ReplyQuote