Forum

 

CR Touch Starts bed...
 
Notifications
Clear all

CR Touch Starts bed leveling off the edge of build plate and stops.


Propellent
(@propellent)
New Member Registered
Joined: 5 months ago
Posts: 1
Topic starter  

Hi, I just purchased the CR Touch for my Ender 3. After following all the guides, I have flashed the firmware of my 32bit mainboard for the CR Touch and set a probe z offset. For whatever reason, when I try to start the levelling process, the probe goes beyond the edge of the build plate in the Y-Axis and the probe begins to drop til it can't go any further down on the Z axis, when it doesn't hit anything it goes back up and the bed leveling stops.

 

Any insight into this problem?


ReplyQuote