Forum

 

Consistent issue de...
 
Notifications
Clear all

Consistent issue dead center on backside of print?


Keadlem
(@keadlem)
New Member Registered
Joined: 3 months ago
Posts: 2
Topic starter  

So got my 3 v2 in today and got it setup (spent a lot of time and made sure everything was level, bed was set, etc.)

firs print was a Benchy. Turned out pretty good overall. Very slight strings-almost unnoticeable. Can tweak for that.

noticeable problem is dead center of the print on the backside- it’s like the back and forth printing don’t connect properly (for lack of better way to put it). Can see it on the hill, and up on the cabin.

started printing come circular stuff next and each circle has the same dead center spots.

not sure what to adjust here.

thoughts.

 


ReplyQuote
Keadlem
(@keadlem)
New Member Registered
Joined: 3 months ago
Posts: 2
Topic starter  

You can see in the tops of the circles that the lines just aren’t exact. Everywhere else on the prints looks great,


ReplyQuote
kevin
(@kevin)
Noble Member Registered
Joined: 7 months ago
Posts: 1045
 

@keadlem  Hi, that is Z seam, there will be some redundant filament at the start and the end of each layer. You will understand how to adjust it in this video.


ReplyQuote