Forum

 

black screen on end...
 
Notifications
Clear all

black screen on ender 3 v2


tntchase
(@tntchase)
New Member Registered
Joined: 12 months ago
Posts: 3
Topic starter  

so i just got this printer for Christmas and i tried to update the firmware and now i just get a black screen all the time. i was wondering if there is a factory reset or something i could do. the screen turns on along with the fans but nothing.


ReplyQuote
LamarDavis
(@lamardavis)
New Member Registered
Joined: 12 months ago
Posts: 2
 

Hey dude,

I had the same issue, wanted to update my Christmas Ender 3 v2 to 1.3.1 and my screen went black. I found a Reddit post that suggested changing the .bin file name to something else. I changed it to "firmware1.bin" and it fixed my issue, hope it works for you also.


ReplyQuote
tntchase
(@tntchase)
New Member Registered
Joined: 12 months ago
Posts: 3
Topic starter  

@lamardavis hey, I did read this and i tried that and its like the printer does not even see that I put anything in it.


ReplyQuote
Eli liu
(@eli-liu)
Member
Joined: 1 year ago
Posts: 462
 

@tntchase firstly, you need to make sure you download the right version of the firmware. For example, you can not use a V4.2.7 firmware for a V4.2.2 board or similar cases. 

you can provide your mainboard version and the firmware you used so I can tell if you get the right one.


ReplyQuote
tntchase
(@tntchase)
New Member Registered
Joined: 12 months ago
Posts: 3
Topic starter  

@eli-liu yes, i have the ender 3 v2 with the v4.2.7 silent motherboard and i downloaded the

Ender-3 V2_32bit_ 2.0.1V Latest Firmware_0814


ReplyQuote
Eli liu
(@eli-liu)
Member
Joined: 1 year ago
Posts: 462
 

@tntchase try this firmware at the download section.

Ender3 V2-4.2.7-32bit_

Marlin-2.0.1_V1.0.1_TMC2225 


ReplyQuote