40mm X Axis Layer s...
 
Notifications
Clear all

[Solved] 40mm X Axis Layer shift!


mlogue9
(@mlogue9)
Heating Block Registered
Joined: 3 months ago
Posts: 15
Topic starter  

Solved. Probably bad driver board. Exchanged it for a new one.

/////////////

I'm talking about a massive layer shift here and it is repeatable. I thought it was octoprint after two bad prints. It started then. But I moved back to SD card and things went well for 8 hours then I fell asleep and found it just as bad. 

I used Cura 4.8 to slice and it's a ender 3 pro. Every medium or larger print will shift - only once so it seems along X axis exactly 40.0mm. Of course my belts are tight, not like that could cause this...

Also it didn't slide i saw it on camera. 

This topic was modified 2 months ago 3 times by mlogue9

ReplyQuote
Scroll Up