Ender 3 Weird lines in the print at specific heights

First post and replies  | Last post by LayItDownLikeAPro, 4 days ago

ender 3 pro fan making strange sounds

First post and replies  | Last post by Chewieiscute26, 3 months ago

Ender 3 Pro Makes Loud unending beep when preheating

First post and replies  | Last post by red909, 3 months ago

Ender3 Pro Thermal Runaway

First post and replies  | Last post by rpiontek, 4 months ago

Filament stop feeding in the middle of the print.

First post and replies  | Last post by MM3DMaker, 5 months ago

Ender 3- start over?

First post and replies  | Last post by MM3DMaker, 5 months ago

Ender 3 X axis is acting weird

First post and replies  | Last post by MM3DMaker, 5 months ago

I saw the Ender-3 V2 deal on slickdeals,but refurb $169

First post and replies  | Last post by Redball, 5 months ago

Need to replace broken switch

First post and replies  | Last post by Tconkle, 5 months ago

What is the name of this printer part and how can I replace it?

First post and replies  | Last post by Maker Mindset, 6 months ago

Ender 3 Pro W BL Touch Axis Will Not Move.

First post and replies  | Last post by dmelo351, 6 months ago

Bed calibration

First post and replies  | Last post by stroland, 7 months ago

My Ender 3 is not booting up on CR Touch firmware 2.0.1 v1.3.1 or 2.0.6 hw4.2.7

First post and replies  | Last post by maciejsozan99, 8 months ago

Ender 3 Prints too high on z access

First post and replies  | Last post by Pauljp, 9 months ago

how to get tube to stay connected at the top where the filament enters?

First post and replies  | Last post by tombogan03884, 1 year ago