Notifications
Clear all

Problem with the home position


Luigi7317
(@luigi7317)
Screw Registered
Joined: 2 months ago
Posts: 1
Topic starter  

Hello.

The "home" point is too close to the edge of the bed on the X axis.

I manually correct the position of the X axis, then I save the parameters, but nothing to do: an auto-home brings the nozzle too close to the edge of the bed !!!

and if I run an impression, it starts at the outer limit of the bed and this causes an agglomeration of molten filament !!!

if I increase the offset of the X axis, when saving the parameter I have the error "toot far ...."

Does anyone have any idea to correct this problem?

Thank's !


ReplyQuote
atlaskin
(@atlaskin)
Nozzle Registered
Joined: 2 months ago
Posts: 3
 

@luigi7317

 

are you running the default firmware that came with the printer ?

 


ReplyQuote
Scroll Up