Forum

 

Notifications
Clear all

printed pla is soft


Audiman
(@audiman)
New Member Registered
Joined: 2 months ago
Posts: 2
Topic starter  

Problems started by a loose nozzle after it banged into bed when bt touch bracket had moved , filament was over hot end cleaned it all up new nozzle fitted.no leak of filament but when I print pla when print finished the item is more like a bit of fabric it is not solid plastic. I'm new to this so on a learning curve here .thank you. 

This topic was modified 2 months ago by Audiman

ReplyQuote
holmes4
(@holmes4)
Trusted Member Registered
Joined: 7 months ago
Posts: 65
 

The only thing I can think of is severe underextrusion. I'd run through the calibration steps at https://teachingtechyt.github.io/calibration.html and see where that gets you.


ReplyQuote