Forum

 

Notifications
Clear all

Firmware Failure!?


Mr.Tom
(@mr-tom)
Active Member Registered
Joined: 5 months ago
Posts: 5
Topic starter  

Hello,

I spent days trying to use the full print area. Never managed to print 30x30!!!
I printed exclusively from the SD card.
Only after I moved the printer to another room so I could connect it directly via USB did it work.

So the full print area of 30x30cm is ONLY possible via US.

I assume that this is a bug?

This topic was modified 2 months ago by Mr.Tom

ReplyQuote
holmes4
(@holmes4)
Trusted Member Registered
Joined: 7 months ago
Posts: 65
 

I am skeptical that there is a bug or that there really is something odd about the SD card. It should not make any difference where the gcode comes from. I wonder if there was a difference in how you sliced the print.


ReplyQuote
Mr.Tom
(@mr-tom)
Active Member Registered
Joined: 5 months ago
Posts: 5
Topic starter  

in one way I say ..print in the other..write to Sd Card. no difference


ReplyQuote