Forum

 

Notifications
Clear all

Ender 3 Max printheads settings configuration in Ultimaker cura V4.8.0


rascalos
(@rascalos)
Active Member Registered
Joined: 1 year ago
Posts: 5
Topic starter  

Hi

A message appears in Creality slicer V4.2.1 concerning Ultimaker Cura V4.8 install.

I installed it but printheads settings can't be change as defined in Ender 4 max documentation:

  • X min should be 26 but stay -26
  • Y min should be 32 but stay -32

Do you have any information to overcome this issue, please.

Thanks for your help.

Regards,


ReplyQuote