can only print 290mm?
in cura I can see the file correct, in preview too.
But if I try to print it, the objekt is max 290mm?
@mr-tom This print size is X:300.5mm Y:200.5mm Z:10mm, but the print is only X:290mm? Then how about the Y and Z direction? Any other flaws on the print?
Ahh, ok, I found something.
A The pressure plate adhesionwas was set to SKIRT.
No it is "nothing"
now I habe 298,7mm
But there are missing 1,3mm...
@mr-tom Could you please share a picture of your print? Also please check the eccentric nut. Is it too tight?