Clear all

Auto Home Does Not Home Z-Axis Resulting in M112 Shutdown.

Nozzle Registered
Joined: 4 weeks ago
Posts: 4
Topic starter  

I don't know what could possibly be wrong with it. I am using firmware built today for Bltouch by the firmware building bot on the Marlin website. Any idea what could be happening? Any fixes? Anything is appreciated!


The attached link shows you what it does when I tell it to home Z on Octoprint.

This topic was modified 3 weeks ago 2 times by Wunderman

Topic Tags
Screw Registered
Joined: 3 weeks ago
Posts: 1


Had something very similar happen.  Had both lines 914 - "Z_MIN_PROBE-USES-Z-MIN-STOP" and 917 - "USE_PROBE_FOR_Z_HOMING" enabled.  If so comment out line 914.  Fixed it for me.

I have the BL Touch with the 5-pin connector connected to the 5-pin header and z-stop unpluged.


Hope this helps.



Scroll Up