Notifications
Clear all
Topic starter
30/11/2020 12:59 pm
I was just wondering if there was a plan to upgrade the firmware to Marlin 2.0x?
Or are you going to release the code you guys use so i can upgrade mine to the 2.0x and keep most of the same selections.
21/01/2021 7:20 am
Not sure how technically minded you are, but https://github.com/InsanityAutomation/Marlin/tree/CrealityDwin_2.0 supports CR-X
I wouldn't use the included .hex files since
- they assume you have a purge bucket for filament change
- the "internal" filament change sequence does not retract the old filament, so filament change does not work at all
- the e-step setting is wrong - at least in my case, firmware set to 95 instead of 140
All of these can be fixed if you know how to modify and build your own firmware - I've been using the above for a couple of weeks now and it works great