Y step motor too ho...
 
Notifications
Clear all

Y step motor too hot


basond
(@basond)
Nozzle Registered
Joined: 2 months ago
Posts: 2
Topic starter  

Hi all

i have cr6-se,

My y axis motor become too hot when works more than 1 hour(can not touch more than 4 seconds burns your hand)

Belt is not too tight so why this happen?

Other motors are very good so,

Should i check vref adjustment?

Which values are necessery for these axis?

Xyz extruder? 

And also which drivers control these step motors on motherboard?(there are 4 driver on it)

 

Thanks all

 

 

This topic was modified 2 months ago by basond

ReplyQuote
dido_75
(@dido_75)
Nozzle Registered
Joined: 3 months ago
Posts: 5
 

Hi! Same problem here. Did you solve it? 


ReplyQuote
Scroll Up