Forum

 

Thermal runaway, i ...
 
Notifications
Clear all

Thermal runaway, i am lost.


martijndk1983
(@martijndk1983)
New Member Registered
Joined: 7 months ago
Posts: 2
Topic starter  

Hello guys,

My brand new cr6se with era board prints for two weeks and now the problems begins.

It won't heat up enough.
When i want to pre heat to 230 it goes to 228 stay there a few seconds and drop down.
210 it goes to 205 stay and drop down etc etc etc.
I changes the temp sensor and the heat probe.

Lost what to do now!


ReplyQuote
kevin
(@kevin)
Noble Member Registered
Joined: 10 months ago
Posts: 1045
 

@martijndk1983 

How about the bed temp?

You may need to check two things.

One is do a PID AutoTune.

Another one is to check your mainboard output voltage on the hot-end port if you have a multimeter, is it 24V?


ReplyQuote