Notifications
Clear all
CR-6 SE
3
Posts
3
Users
0
Likes
920
Views
Topic starter
20/04/2021 8:11 am
Hello, the lower left corner of the bed is too high.
20/04/2021 10:55 am
@nono Obviously, the front left corner is too high, and the others are a little low.
Sorry I didn’t notice it is 6SE, take the build plate off and check the screw on front left corner that whether it tight enough.
22/04/2021 1:09 pm
heat up the nozzle, clean the filament residue if there’s any then do the auto level again. Sometimes the residue will affect the leveling result.
