Forum

 

Replacing the hotbe...
 
Notifications
Clear all

Replacing the hotbed glass plate after printing


Chris4001
(@chris4001)
New Member Registered
Joined: 2 months ago
Posts: 2
Topic starter  

Hi - I have just set up my new CR-6 SE and completed my first print. I removed the glass to remove the print. I cannot replace the glass - the back catches are too stiff. Please help.


ReplyQuote
Chris4001
(@chris4001)
New Member Registered
Joined: 2 months ago
Posts: 2
Topic starter  

I slept on it....

The screws holding down the clips at the back of the hot plate were way too tight. I have now loosened them. All good


ReplyQuote
kevin
(@kevin)
Noble Member Registered
Joined: 7 months ago
Posts: 1045
 

@chris4001 LOL, CR-6SE unique design,


ReplyQuote