Forum

 

PEI bed too low on ...
 
Notifications
Clear all

PEI bed too low on CR-6 SE


tswed
(@tswed)
New Member Registered
Joined: 4 months ago
Posts: 1
Topic starter  

Got a CR-6 SE a few months back and I've been have adhesion issues with the glass bed.  My prints were cemented to the bed.  I bought a Creality branded PEI bed to see if I liked that better.  Seems like the bed isn't thick enough as the X gantry runs into the Z sensor before the nozzle can reach it during auto bed leveling.

Any advice?  It doesn't look like I can move the Z sensor.


ReplyQuote
Topic Tags