Cr -6 SE Levellign problem

First post and replies  | Last post by Sebbo147, 8 months ago

Z-axis raises up about 1cm on left hand side

First post and replies  | Last post by Anchoright, 8 months ago

Z-axis raises up about 1cm on left hand side

First post and replies  | Last post by Anchoright, 8 months ago

PEI bed too low on CR-6 SE

First post and replies  | Last post by tswed, 9 months ago

My CR-6-SE crashes after about an hour of printing

First post and replies  | Last post by kyleservicetech, 9 months ago

My CR-6-SE crashes after about an hour of printing

First post and replies  | Last post by kyleservicetech, 9 months ago

Any suggestion for getting a CR-6SE?

First post and replies  | Last post by CYT, 9 months ago

Can anyone help with 2 problems?

First post and replies  | Last post by pete87, 9 months ago

Extruder Calbiration

First post and replies  | Last post by nnangeroni, 9 months ago

major layer shifting

First post and replies  | Last post by warddw, 10 months ago

Hotend connections

First post and replies  | Last post by Tauzero, 10 months ago

[Novice] How to însert the PLA filament (First use)

First post and replies  | Last post by pierrot10, 10 months ago

la buse et le plateau de ma Sr 6se ne chauffe plus

First post and replies  | Last post by biboune01, 10 months ago

Underextrusion after replacing extruder casing

First post and replies  | Last post by Palagast, 10 months ago

Printer never finishes booting

First post and replies  | Last post by mightymahree, 10 months ago