Notifications
Clear all
Topic starter
16/02/2022 12:41 am
Hello,
I am very new and I bought my first CR6 SE. It's the first time I use a 3D priter.
I have a very simpele question. I have a PLA string and insert the string.
I supposes I have first to heat the printer by pressing "Preheat PLA". Then I have to insert and oush the wire until the buse? Until I can not push it more? Or should I just insert the wire until it get inside the white pipe.
I will next use PET. How can I use the printer with PET instead of PLA. I only see Preheating PLA and ABS. I mainly baught it for PET wire.
Last question, I have a spare bag