Forum

 

No chance to level ...
 
Notifications
Clear all

No chance to level the CR-6 SE


Macbambi
(@macbambi)
Active Member Registered
Joined: 6 months ago
Posts: 5
Topic starter  

Hi,

look at the picture. I screwed everything tight, but no chance to get a good print.

Why does the chip in the CR-6 not remember the level of each sector?

Then for what is the Levelling good for? 

Regards,

Frank


ReplyQuote
Topic Tags
kevin
(@kevin)
Noble Member Registered
Joined: 7 months ago
Posts: 1045
 

@macbambi The bed bottom left corner is too high, it may be beyond the adjustment range of BLtouch. Try to higher the Z-offset a little to balance the others corners.

If still does not work, I recommend you contact the customer services to send you a new bed. The bed has a unflat issue that you can not adjust it well.


ReplyQuote
Macbambi
(@macbambi)
Active Member Registered
Joined: 6 months ago
Posts: 5
Topic starter  

Hi Kevin,

 

thank you very much for your help.

If I set the adjustment range to the maximum the left corner in front is still to high,
while the other ones to deep. 
The Glass Plate has also become some bad scratches causing this fault by the nozzle.

I just informed the Service and asked for a new bed.

I will reply when I got the answer.

Regards,

Frank


ReplyQuote
kevin
(@kevin)
Noble Member Registered
Joined: 7 months ago
Posts: 1045
 

@macbambi

Hi Frank

You are welcome. Good luck! 

Kevin


ReplyQuote
Macbambi
(@macbambi)
Active Member Registered
Joined: 6 months ago
Posts: 5
Topic starter  

Now after 3 weeks I’m very disappointed. 
No help from Creality, no service, nothing!

Meanwhile I figured out that some parts of the printer were already broken when the printer arrived. 

The Ender 3 was a very good printer, but the CR-6 SE is a piece of sh…

 

I will never buy anything from Creality again and 
I will start an info campaign on my homepage to warn of that printer. 


ReplyQuote