matrix showing not ...
 
Notifications
Clear all

matrix showing not showing Z-offsets


midwestken
(@midwestken)
New Member Registered
Joined: 1 month ago
Posts: 3
Topic starter  

How do I get the display to show the Z-offsets ?   All the display shows is the 16 points it used during the self level?  Is there a setting I'm missing?  

Model CR6-SE, firmware 2.0.1.3

This topic was modified 1 month ago by midwestken

ReplyQuote
kevin
(@kevin)
Prominent Member Admin
Joined: 5 months ago
Posts: 900
 

@midwestken You have no the attached page on display?


ReplyQuote
midwestken
(@midwestken)
New Member Registered
Joined: 1 month ago
Posts: 3
Topic starter  

@kevin Thanks for the response....no I was referring to the self leveling screen itself.  Trying to follow the prompts to make sure my bed is perfectly level.  However all the steps refer to the Z-offsets numbers that is displayed on the self leveling screen.   All I see is attached.   


ReplyQuote