Just a beginner que...
 
Notifications
Clear all

Just a beginner question


bbinkerd
(@bbinkerd)
Nozzle Registered
Joined: 3 months ago
Posts: 4
Topic starter  

I have my CR-6 SE set up and I've even gone through the bed leveling from the users manual. The problem now is that as this is my very first foray into 3d printing, I don't know what the <bleep> I'm doing. I'd like to get some recommendations for where to start - primarily any good beginner-oriented books about 3d printing that would hold my hand to a certain extent. Obviously it would be nice if the books were written with Creality printers in mind.

Thanks much.


ReplyQuote
Eli liu
(@eli-liu)
Power Supply Customer
Joined: 7 months ago
Posts: 462
 

words are not enough for this. I suggest you go to the tutorial section or youtube to watch some 3D printer videos. You will gain a lot.


ReplyQuote
Scroll Up