Notifications
Clear all
Topic starter
01/07/2021 7:05 am
I have just setup my Cr6 SE, got unit setup and bed leveled.
I put the sd card in and went to print a test file, but no files show up in the menu. The sd card is stock as it comes from the factory i haven't edited it. Shouldnt there be test files on there showing up that can be printed.
Topic starter
01/07/2021 7:46 am
Not sure what it was, I took another SD card i had laying around, formatted it to fat32. Then copied the model files over from the original and now it reads them..