Forum

 

hot Nozzle temperat...
 
Notifications
Clear all

hot Nozzle temperature control unstable


DOVK179
(@dovk179)
New Member Registered
Joined: 2 years ago
Posts: 2
Topic starter  

Just upgraded the firmware to cr6 rel 5 and noticed that, up to the temperature of 220 degrees the nozzle temperature is oscillating 3 or 4 times around the target temperature and then the print stats. good temperature targeting.

I was trying to print ABS with 230 degrees and found out that the oscillations around the target temperature are non stop. I paused and started again few times until it started to print.

My solution was back to PLA.


ReplyQuote