Forum

 

Error code 202 Homi...
 
Notifications
Clear all

Error code 202 Homing failes


MF63
 MF63
(@mf63)
Active Member Registered
Joined: 11 months ago
Posts: 16
Topic starter  

Hello,

This morning I powered up my 3 months old CR-6 SE printer but the homing was not OK.

The nozzle does not touch the glass plate.

I did an automatic leveling but the nozzle did stll not touching the plate.

The nozzle stays about 1 cm above the plate and then it moves up again.

 After a while on the screen I have this message:  “Homing failes” “ error 202”

 

I did a new FW update of the main board , but no results.

I removed the metal cover of the nozzle and when I touch manual the nozzle (automatic leveling) , there is no Led to light up

 

What is the problem and how can I fix this ?

 


ReplyQuote
Bossjim
(@bossjim)
New Member Registered
Joined: 4 days ago
Posts: 1
 

Is there a solution to this problem,I have the same issues 


ReplyQuote