Notifications
Clear all
Topic starter
25/12/2020 2:17 pm
Hi All,
Just finished setting up my new CR-6 SE printer today, got to the auto leveling section and ended up with magic smoke after about 30 seconds - quickly turned off nothing seems hot and no melted cables.
Suggestions? - send it back? is there anything I should check and try again?
Absolutely gutted....
Thanks
Steve
25/12/2020 2:31 pm
Find out where the smoke came from (most likely from the mainboard or the power switch). You need to ask the seller for a replacement of whatever the damaged part is.