Brand new unit bounces entire print head off glass for 60 seconds, sends back homing error 202

First post and replies  | Last post by bushxw00kie, 5 days ago

homing not correct

First post and replies  | Last post by jverbeeck, 1 month ago

Drunk Printhead ?! HELP!

First post and replies  | Last post by iTaranis, 6 months ago

Still USB Problems

First post and replies  | Last post by Cr6Se11, 9 months ago

Clicking Noise while Feeding Filament

First post and replies  | Last post by jc_816, 1 week ago

CR-6 SE Extruder Upgrade

First post and replies  | Last post by jc_816, 1 week ago

CR6-SE Error 204

First post and replies  | Last post by Christ49Fr, 1 week ago

Creality Wifi Box Terminating print mid-job

First post and replies  | Last post by Will2930, 3 weeks ago

Prints fail randomly, printer reboots

First post and replies  | Last post by cosmicinsane, 3 weeks ago

CR-6 - Print Nozzle driving into the bed

First post and replies  | Last post by Katsa, 1 month ago

CR6 se - Error 203 on Auto-Level - New Machine

First post and replies  | Last post by chilz822, 2 months ago

Cr -6 SE Levellign problem

First post and replies  | Last post by Sebbo147, 2 months ago

Z-axis raises up about 1cm on left hand side

First post and replies  | Last post by Anchoright, 2 months ago

Z-axis raises up about 1cm on left hand side

First post and replies  | Last post by Anchoright, 2 months ago

PEI bed too low on CR-6 SE

First post and replies  | Last post by tswed, 2 months ago