Forum


 

Notifications
Clear all

Tiny Machines Z Sync Kit Question

1 Posts
1 Users
0 Likes
488 Views
Goldglv
(@goldglv)
New Member
Joined: 9 months ago
Posts: 1
Topic starter  

I’m going to install this Z Sync kit because my gantry will not stay level.  I’ve seen most people follow the TM instructions installing the kit right below the horizontal bar (below the bearing block) that the spool holder sits on.

But I’ve seen a few people install them on top of the horizontal bar (above the bearing block).  Anyone know if it matters where to install these?

Below is the tiny machines installation instructions

https://docs.google.com/document/d/1O83ybzgVLAP3oe2oyRb-H-YRIGRg5zgpeaQ7vnh-ZeM/edit

 

 


   
ReplyQuote