Fan problem

First post and replies  | Last post by kevin, 2 years ago

reversed cable from filament sensor… started smoking..

First post and replies  | Last post by kevin, 2 years ago

CR-10S Pro V2 – How to reduce hotbed heater power consumption

First post and replies  | Last post by kevin, 2 years ago

CR-10S Pro V2 main board

First post and replies  | Last post by kevin, 2 years ago

What nozzle for the CR-10 pro V2

First post and replies  | Last post by 校工叔叔(Mr. Au), 2 years ago

Large prints warping/curling

First post and replies  | Last post by kevin, 2 years ago

Help CR-10S pro heated bed grounding cable

First post and replies  | Last post by Lankybean, 2 years ago

More issues with Pro V2

First post and replies  | Last post by kevin, 2 years ago

Help , irregular filament flow CR-10S Pro V2

First post and replies  | Last post by kevin, 2 years ago

CR-10S pro V2 pretends it prints but just doesn't

First post and replies  | Last post by kevin, 2 years ago

bowden tube pops loose of pneumatic connectors

First post and replies  | Last post by Eli liu, 2 years ago

Filament detector not stopping printhead?!?

First post and replies  | Last post by staffert, 2 years ago

CR-10 MAX thermistor issues

First post and replies  | Last post by Eli liu, 2 years ago

Sounds at conclusion

First post and replies  | Last post by papaSteve, 2 years ago

Unable to adjust z-axis

First post and replies  | Last post by obiwan007, 2 years ago