Forum


 

Notifications
Clear all

CR10 S Pro. help with Bed adhesion

2 Posts
2 Users
0 Likes
328 Views
Iczer1
(@iczer1)
New Member
Joined: 6 months ago
Posts: 1
Topic starter  

Greetings Programs,

I recently bought a CR10S Pro; and for the past week and half. been trying to dial in on the best settings.  I’ve got to where using a raft works, but when I try to print with a skirt or nothing at all, prints go wonky.  IE, the skirt is not forming the “shape” around the object, or when I print without anything doesn’t stick.

 

I have the Z-offset as low as -2.65, just above the bed, but nothing works.  Please advise.

 

Thank you!!


   
ReplyQuote
KbJockey
(@kbjockey)
New Member
Joined: 5 months ago
Posts: 1
 

@iczer1 The best thing I have found for bed adhesion with all filaments is the BefanyBay PEI surface. I found it on Amazon. I have had very few failures and those were because my bed leveling got off and the head was too high.


   
ReplyQuote