cr10 max nozzle crashing into the bed

First post and replies  | Last post by jengler, 3 weeks ago

Cr10s Pro V1 dual Extruder?

First post and replies  | Last post by Ericmurray, 5 months ago

bed adhesion is too good

First post and replies  | Last post by mydogexcitesmeattimes, 5 months ago

X-axis motor making a terrible noise

First post and replies  | Last post by Ericmurray, 5 months ago

Please help! My heat nozzle keeps going through the bed

First post and replies  | Last post by Ginz, 5 months ago

Cr-10s Pro fährt beim Autoleveln immer höher

First post and replies  | Last post by Genervt52, 7 months ago

X/Y/Z Axis

First post and replies  | Last post by kroegi, 7 months ago

CR10 S Pro. help with Bed adhesion

First post and replies  | Last post by KbJockey, 7 months ago

Cr10 s pro v2 noise

First post and replies  | Last post by Cdcrossy, 9 months ago

Cr-10S pro v2 _ building/bed/timing-belt_notches/bump feeling

First post and replies  | Last post by Pat_at_the_lake_retired, 9 months ago

Z motor NOT moving

First post and replies  | Last post by Picengraver, 9 months ago

Cr10s pro – nozzle crashing into the bed when z-homing

First post and replies  | Last post by Wheelturns, 11 months ago

Attaching laser kit to CR-10S PRO V2

First post and replies  | Last post by gerrydeguzman, 11 months ago

Tiny Machines Z Sync Kit Question

First post and replies  | Last post by Goldglv, 11 months ago

In need of control board diagram for CR10S PRO V2

First post and replies  | Last post by DAVID9874, 11 months ago