Notifications
Clear all
Topic starter
23/12/2020 6:06 pm
Hi everyone,
i have cr10-s pro v2, i have problem about home axis, when I push "home" extruder is not go to middle of bed. it is going to about -40mm X and -300mm Y from the middle. This started after use simlify3d , I have this problem when I do leveling and when I start to printing. I need your helps.
25/12/2020 11:05 am
I don't think the slicer could change the printer default settings. Could you provide a video so I can tell what's going on to the printer. Or you can reflash the firmware, or
M502 - Factory Reset
Forum Statistics
24
Forums
945
Topics
4,220
Posts
5
Online
4,172
Members
Latest Post: Design software Our newest member: fishexyvp221 Recent Posts Unread Posts
