CR10S V3 Titan Dire...
 
Notifications
Clear all

CR10S V3 Titan Direct Drive heat block clog


Mikey369M
(@mikey369m)
New Member Registered
Joined: 2 months ago
Posts: 2
Topic starter  

Newbie with a Creality CR10S V3 Titan Direct Drive. Worked fine with PLA+ until shortly after I started printing PETG (1.75mm Amazon Basics). Definitely believe my setup was incorrect (temp and maybe retraction) - I’m now clogged throughout the cool area.

Took the .4mm brass nozzle off and pushed a hex wrench up to it’s length @ 252C (don’t know the max temp for the Titan). Could pass filament thru the “wrench” hole but I suspect I’ll need to fully clean out the clog.

Not sure of the best course of action. Anyone have any "unclog" suggestions?


ReplyQuote
kevin
(@kevin)
Prominent Member Admin
Joined: 5 months ago
Posts: 910
 

@mikey369m 

  I think this is the most detailed explanation to let you understand why nozzle clog.


ReplyQuote