Notifications
Clear all
Topic starter
18/05/2022 3:20 am
I was servicing the hot end and heard a small pop. No spark or smell. Once I finished with the service, I turned on the printer and the temps displayed were far off. The hot end said -14 C and the bed said +233 C. I checked connections and they were fine. I replaced the hot end assembly minus the titan drive and still no help. After turning it on, I waited a few minutes to see if the bed was actually trying to heat up to 233 C but I didn’t feel and increase in temp. If I try to go into the menus, I get an error that the bed temp is maxed (Or something like that). I may have shorted something out but I am not sure where to start checking or if there are any tests I can run. Any help would be appreciated.
Steve