Forum

 

CR-10 V2 Cooling fa...
 
Notifications
Clear all

CR-10 V2 Cooling fan issue


Duckbang
(@duckbang)
New Member Registered
Joined: 1 year ago
Posts: 2
Topic starter  

Hi,

I accidentally broke a blade off my fan (still worked, just vibrated a bit). Anyway I went to change it and the connector on the small board under the extruder/run-out sensor came off! the fan now will not work. Can I get a new board?? its only the small one and I cant seem to find it anywhere..


ReplyQuote
Eli liu
(@eli-liu)
Member
Joined: 2 years ago
Posts: 462
 

I went to change it and the connector on the small board under the extruder/run-out sensor came off

lol, this happens a lot to me. The connector came off, but the metal pin still on the board. Simply insert the fan port back. PUT EVERYTHING BACK TO WHERE IT WAS. No need to buy a new board.


ReplyQuote
Duckbang
(@duckbang)
New Member Registered
Joined: 1 year ago
Posts: 2
Topic starter  

Hi,

Yeah, I thought that to but it still wouldn't work... so I've MacGyver'ed it! ? 

Ive plugged a new fan direct into the mainboard and cable tied it back to the hot end... it works!


ReplyQuote