Notifications
Clear all
Topic starter
22/06/2021 9:40 pm
I can’t get through leveling, the printer returns a 203 (Probing Failed Error). I'm not sure how to progress.
Also… is the bed supposed to have this much movement?
Thanks in advance!
23/06/2021 10:31 am
@studio2f No, the bed do not suppose to be that. You have to adjust your eccentric nuts under your bed.
24/06/2021 8:51 pm
@studio2f You don't want to make them too tight that they bind up, but take your finger and spin them when it's not moving. They shouldn't spin freely.
Topic starter
25/06/2021 3:52 am
I've tightened them as far as they will go, and the bed still has that wobble. they just don't seem to be close enough to the rail they ride on.
25/06/2021 2:51 pm
@studio2f Well. It is likely that the V profile is deformed or the hotbed is deformed. Contact the seller to get a new one.