CR-10 S5 Err: Chang...
Clear all

CR-10 S5 Err: Change Filament

New Member Registered
Joined: 4 months ago
Posts: 1
Topic starter  

I have a CR-10 S5 that i have been using for almost 2 years without issue.  Initially when i set it up i made the decision to NOT install the filament sensor as it was the cause of many issues.  That was great until last night where I got a error.... it said Err: Change Filament.

There is not a filament clog as i can see the filament come out when i provide a little pressure.  I have re-seated all connectors. 

What should i check now?  Im stuck.