Forum

 

Notifications
Clear all

CR-10 MAX


Witz
 Witz
(@witz)
New Member Registered
Joined: 8 months ago
Posts: 2
Topic starter  

I have leveled all 4 corners of the bed but the center sags leaving 4x the gap of the corners.  When I run a large print the first layer will not adhere in the middle of the bed. 

I ran auto level to measure the entire bed but when I run a print the Z-axis does not move up and down to compensate for the sag in the middle.  How can I get the auto level to do its job or how can I level the middle of the bed?


ReplyQuote
Topic Tags
kevin
(@kevin)
Noble Member Registered
Joined: 9 months ago
Posts: 1045
 

@witz Put a metal ruler on its side to check as attached picture. I know that some of the build plates are not flat. You may need a BLTouch sensor in such cases.

Or you could make it adjustable to get or create a support piece or shim under the center of the bed.


ReplyQuote
Witz
 Witz
(@witz)
New Member Registered
Joined: 8 months ago
Posts: 2
Topic starter  

@kevin Thanks.  My bed is similar to yours with a droop in the middle.  I figured out how to adjust the z for auto leveling.  It now appears to be working.  Appreciate the response.


ReplyQuote
kevin
(@kevin)
Noble Member Registered
Joined: 9 months ago
Posts: 1045
 

@witz ? Glad to hear you fixed it. Enjoy your printing.


ReplyQuote