Notifications
Clear all

BTT Board & Screen


minibarrow
(@minibarrow)
Nozzle Registered
Joined: 3 months ago
Posts: 6
Topic starter  
Hi all, Have install the TFT35 E3 V3.0 & SKR Mini E3 V1.2 into my stock CR-10. Have complied the config.h & config-adv.h files for the board, also the config.ini for the screen. Have set the screen and baord baud rates to 115200 but am still getting a 'No printer attached' message on my screen. Have tried to change the baud rate but to no avail.
Is there anything I have missed or I can try.

ReplyQuote
Scroll Up