Forum

 

Notifications
Clear all

bowed glass and bed


clownnut
(@clownnut)
Active Member Registered
Joined: 5 months ago
Posts: 5
Topic starter  

ok, i got a cr-10 S4 with both glass and bed bow at the center. if i adjust the 4 corner to paper height. the center of the bed is about 5 pages can go under the nozzle.

what's my best bet to fit this issue? new glass? bltouch?(i think that mean i need a new board as well).

thanks for your input.

 


ReplyQuote
kevin
(@kevin)
Noble Member Registered
Joined: 7 months ago
Posts: 1045
 

@clownnut Hello, here are some tips in my own experience: As your bed bow as well, only change a new glass will not help I think.

1. Bltouch is a good method to address this issue.

2. Balance The Bed Level With Other Materials,like add layers of foil tape to balance it out because foil has good heat transfer properties.

3. Using levelling knobs to flatten the printer bed and then change a new build plate.

4. Replace the print bed and build glass altogether.

 


ReplyQuote
clownnut
(@clownnut)
Active Member Registered
Joined: 5 months ago
Posts: 5
Topic starter  

@kevin
thanks for the reply.
its unfortunate that the print bed is bow this much.
i will stay with adding layer of foil tape and new build glass see if that solve my problem before doing bltouch and new board.

This post was modified 5 months ago by clownnut

ReplyQuote