Forum


 

BL Touch for CR10V3…
 
Notifications
Clear all

BL Touch for CR10V3 zeros off bed by 2.8mm and I can't get mesh to work at all.

1 Posts
1 Users
0 Likes
655 Views
tworrell21
(@tworrell21)
New Member
Joined: 2 years ago
Posts: 2
Topic starter  

Every time I home the z-axis the Bl touch hits the bed but ends up zeroing the nozzle 2.75mm above the bed. I have the limit switch removed so that’s not the issue. The bl touch is installed property so I have no idea why it’s off by a consistent 2.8mm  

 

I also have noticed that the bl touch will go through the full mesh leveling process (all 16 points) but then once the print starts the nozzle will run into the bed in some place (I thought the bed leveling would make it so this wouldn’t happen and I didn’t need to dink around with the leveling wheels 


   
ReplyQuote