Help!! CR10 upgrade to V4.2.2 Motherboard and Firmware

First post and replies  | Last post by Ground Source, 4 weeks ago

CR10

First post and replies  | Last post by Ground Source, 2 weeks ago

CR10 v3

First post and replies  | Last post by Affleck001, 4 weeks ago

Bed cools down on pause & ruins print

First post and replies  | Last post by BlindSquirrel, 1 month ago

CR-10 Smart print plate replacement?

First post and replies  | Last post by KriegTiger, 2 months ago

CRX troubleshooting - Potential heat creep?

First post and replies  | Last post by 校工叔叔(Mr. Au), 3 months ago

Thermal runaway on 1.1.6?

First post and replies  | Last post by kevin, 3 months ago

CR10S Pro V2 Z offset Not working

First post and replies  | Last post by kevin, 3 months ago

Cr 200b Parts and upgrade

First post and replies  | Last post by kevin, 3 months ago

CR-200B BL Touch Firmware

First post and replies  | Last post by kevin, 3 months ago

CR-200B

First post and replies  | Last post by kevin, 3 months ago

CR-10 Smart Connect to PC/Pi

First post and replies  | Last post by z0mbie_, 3 months ago

CR30 Printmill

First post and replies  | Last post by kevin, 3 months ago

CR-5 pro H Firmware-Problem

First post and replies  | Last post by kevin, 4 months ago

CR-200B Power Loss Recovery feature

First post and replies  | Last post by kevin, 4 months ago