Forum

 

Notifications
Clear all

M603 values


brthfs
Posts: 2
Registered
Topic starter
(@brthfs)
New Member
Joined: 7 months ago

Hi,

Can somebody share the M603 values in this firmware (these values are used for the M600 command).

Thanks

B

Reply
2 Replies
Marlin Firmware Service
Posts: 209
(@marlin-firmware-service)
Estimable Member
Joined: 11 months ago

This would depend on the printer - however the defaults would be from the Marlin Configuration files:

https://github.com/MarlinFirmware/Configurations/tree/bugfix-2.0.x/config/examples/Creality

Reply
1 Reply
brthfs
Registered
(@brthfs)
Joined: 7 months ago

New Member
Posts: 2
Posted by: @marlin-firmware-service

This would depend on the printer - however the defaults would be from the Marlin Configuration files:

https://github.com/MarlinFirmware/Configurations/tree/bugfix-2.0.x/config/examples/Creality

Are you sure you kept it default?

I found this for the V2:

 

#define FILAMENT_CHANGE_UNLOAD_LENGTH 100 // (mm) The length of filament for a complete unload.
  // For Bowden, the full length of the tube and nozzle.
  // For direct drive, the full length of the nozzle.
 

// Set to 0 for manual unloading.

Reply