Forum

 

Ender 3 Power Loss ...
 
Notifications
Clear all

Ender 3 Power Loss Recovery


Rick
Posts: 1
 Rick
Registered
Topic starter
(@rick)
New Member
Joined: 5 months ago

Ender 3 32 bit board V 4.2.2

Downloaded and flashed Ender3-Stock-20210531.hex from Marlin Firmware service.  Love it.   Works great.

But I enabled the power loss recovery function by selecting "on" and tested it.    After a power loss and restarting, the option to resume the print was there and the print restarted, but it restarted from the origin, overprinting from the original start point instead of resuming where it left off.   Anyone else have the same issues?  I live in a 3rd world country where the power goes out often, so this option is necessary. 

Reply
1 Reply
1 Reply
kevin
Registered
(@kevin)
Joined: 8 months ago

Noble Member
Posts: 1045